LeSabre V6-3.8L VIN K (1996)
30. If screen displays "BLEED PROCEDURE COMPLETE," select "UP" button.
31. Release bleed pressure, following bleed equipment manufacturers instructions. Select "UP" button.
32. Disconnect bleed equipment. Clean up any spilled brake fluid by wiping up as much as possible, then flushing area with water. Do not allow any
water to enter master cylinder reservoir. Select "EXIT".
33. Depress brake pedal. It should be high and firm. If not, re-inspect brake system thoroughly for any conditions which could cause excess brake
pedal travel. If brake system is OK, and excess pedal travel persists, repeat Auto Bleed Procedure.
