LeSabre V6-3.8L VIN K (1996)
-
J 35589 Bleeder Adapter
1. Fill master cylinder reservoir to full mark using only Delco Supreme II Brake Fluid, or equivalent DOT-3 brake fluid.
2. Install J 35589 bleeder adapter to the master cylinder.
3. Charge J 29532 to 140 to 172 kPa (20 to 25 psi).
4. Connect J 29532 hose to adapter and open the line valve.
5. Raise vehicle and suitably support.
6. If you must bleed all the wheel circuits, use the following sequence: Right rear, left rear, right front, and then left front.
7. Remove bleeder valve cap and place proper size box-end wrench, or J 21472 / J 28434. over bleeder valve.
8. Attach a transparent tube to bleeder valve, submerge other end of tube in a clear container partially filled with clean brake fluid.
9. Loosen bleeder valve at least 3/4 turn, and allow fluid to flow until no air is seen in the fluid.
10. Tighten bleeder valve.
TIGHTEN
-
Wheel cylinder bleeder valve to 7 Nm (62 lb. in.).
-
Caliper bleeder valve to 13 Nm (10 lb. ft.).
11. Repeat Steps 7 through 10 until all calipers/cylinders have been bled. Then install bleeder valve caps.
12. Lower vehicle.
13. Check brake pedal for "sponginess". Repeat entire bleeding procedure to correct "sponginess".
14. Remove J 29532 and J 35589.
15. Fill master cylinder to full mark.
