LeSabre V6-3.8L VIN K (1996)
Air Bag Control Module: Customer Interest
Side SIR Module & Instrument Panel Trim Plate - Gap
File In Section: 9 - Accessories
Bulletin No.: 83-90-11
Date: May, 1998
Subject:
Gap Fit Between Passenger SIR Module and the Instrument Panel Trim Plate (Remove and Reinstall PSIR Module)
Model:
1994-98 Buick LeSabre
Condition
Some customers may comment about on a gap between the passenger supplemental inflatable restraint (PSIR) module and the instrument panel trim
plate.
Correction
Remove the PSIR module, then reinstall. Follow the procedure described in Section 9J of the appropriate Service Manual. When installing the PSIR
module, make sure it is properly located. First install the top two fasteners, then the bottom two fasteners. It is necessary to do this in order to properly
locate the PSIR module. When installing the trim plate, push in both sides at the same time. If one side is pressed in first, it will result in a gap between
the PSIR module and the trim plate.
Important:
Do not attempt to repair the PSIR module. This module is serviced by replacement only.
Warranty Information
For vehicles repaired under warranty, use:
Labor Operation
Description
Labor Time
C8836
Module - Passenger
0.7 hr
Inflatable Cushion
(SIR System) - R & R or Replace
Add
For Diagnostic Time
0.0 - 0.3 hr