LeSabre Estate Wagon V8-350 5.7L DSL (1982)
6.
Install assembly in injection pump until locknut contacts pump housing. Tighten locknut.
7.
Place transmission in park, turn A/C off and start engine.
8.
Loosen locknut and slowly turn metering valve stop screw clockwise until idle speed drops approximately 10 RPM.
9.
Turn metering valve stop screw counterclockwise 3 turns on Estate wagons and 2-1/2 turns on all except Estate wagons and tighten locknut.
10.
Check installation for fuel leaks and remove shop towel from intake valley.
11.
Turn engine off.
12.
Remove magnetic tachometer probe and screened covers from intake manifold and reinstall parts removed.
VEHICLE EMISSION CONTROL INFORMATION UPDATE GENERAL MOTORS CORPORATION
13.
Type or print with ball point pen the dealer code and date in the space provided on the supplemental emission control label, part number
14057201 or equivalent, Figure 3 (part of kit). The label must be placed next to the existing underhood emission control information label to
the extent possible. The label should not be affixed to any equipment that can be easily detached from the vehicle. Wash off the area with
soap and water, dry thoroughly, and apply the new label.
