Lucerne V6-3.8L (2007)
13. Slowly raise the module until the vapor line quick connect fittings (1) are visible.
14. In order to prevent the internal vent lines from dropping into the raw gasoline, tie a string to the lines and secure.
15. Disconnect the vapor line quick connect fittings (1 and 2) from the module flange.
16. Slowly raise the sender until the fuel level sensor float arm is just visible.
Important: When removing the sender from the fuel tank, be aware that the sender reservoir bucket is full of fuel. The sender must be
tipped slightly during removal to avoid bending the fuel level sensor float arm.
17. Tilt the sender toward the rear of the fuel tank to allow the level sensor float arm to clear the tank opening. Remove the sender from the tank.
18. Carefully discard the fuel in the sender reservoir bucket into an approved fuel container.
Important: DO NOT reuse the old fuel pump sender seal.
19. Remove and discard the fuel pump sender O-ring seal.
