Lucerne V6-3.8L (2007)
Notice: Avoid damaging the lock ring. Use only J-45722 to prevent damage to the lock ring.
Notice: Do Not handle the fuel sender assembly by the fuel pipes. The amount of leverage generated by handling the fuel pipes could damage the
joints.
Important:
*
The fuel sender assembly may spring up from its position.
*
When removing the fuel sender assembly from the fuel tank, be aware that the reservoir bucket is full of fuel. It must be tipped
slightly during removal to avoid damage to the float. Discard the fuel sender assembly O-ring seal and replace it with a new one.
*
Carefully discard the fuel in the reservoir bucket into an approved container.
Important: Do NOT use impact tools. Significant force will be required to release the lock ring. The use of a hammer and screwdriver is
not recommended. Secure the fuel tank in order to prevent fuel tank rotation.
Use the J 45722 and a long breaker-bar in order to unlock the fuel sender lock ring. Rotate the lock ring in a counterclockwise direction.
9. Remove the J 45722 and the fuel sender lock ring.
10. Slowly raise the sender until the fuel level sensor float arm is just visible.
Important: When removing the sender from the fuel tank, be aware that the sender reservoir bucket is full of fuel. The sender must be
tipped slightly during removal to avoid bending the fuel level sensor float arm.
