Lucerne V6-3.8L (2007)
Important:
*
Some lock ring were manufactured with DO NOT REUSE stamped into them. These lock rings may be reused if they are not damaged
or warped.
*
Inspect the lock ring for damage due to improper removal or installation procedures. If damage is found, install a NEW lock ring.
*
Check the lock ring for flatness.
Place the lock ring on a flat surface. Measure the clearance between to lock ring and the flat surface using a feeler gage at 7 different points.
20. If the warpage is less than 0.41 mm (0.016 in), the lock ring does not require replacement.
21. If the warpage is greater than 0.41 mm (0.016 in), the lock ring must be replaced.
Installation Procedure
1. Place a NEW fuel pump sender O-ring seal onto the fuel tank.
Important: The bucket must be tipped slightly during installation to avoid bending the fuel level sensor float arm.
2. Tilt the sender toward the rear of the fuel tank to allow the fuel level sensor float arm to clear the tank opening. Install the sender into the fuel tank.
3. Lower the sender assembly into the tank.
