Lucerne V6-3.8L (2007)
8. Position the fuel feed pipe and harness connectors.
9. Connect the fuel level sensor wiring harness electrical connectors (1, 2) to the pressure sensor and sender.
10. Connect the fuel feed rear pipe quick connect fitting (3) to the sender.
11. Connect the negative battery cable. Refer to See: Fuel Line Coupler/Service and Repair/Plastic Collar Quick Connect Fitting Service
12. Perform the following procedure in order to inspect for leaks:
1. Turn ON the ignition, with the engine OFF for 2 seconds.
2. Turn OFF the ignition for 10 seconds.
3. Turn ON the ignition, with the engine OFF.
4. Inspect for fuel leaks.
13. Install the fuel sender access hole cover.
Notice: Refer to Fastener Notice.
14. Install the fuel sender access hole cover bolts.
