Lucerne V6-3.8L (2007)
Vehicle Speed Sensor: Service and Repair
4T65-E - Automatic Transaxle
Vehicle Speed Sensor Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the electrical connector at the vehicle speed sensor.
3. Remove the retaining bolt (9) and the sensor (10).
Installation Procedure
1. Inspect the O-ring (11). If damaged, replace as necessary.
Notice: Refer to Fastener Notice.
2. Install the vehicle speed sensor (10) and the retaining bolt (9).
Tighten the bolt to 12 N.m (106 lb in).
3. Connect the electrical connector to the sensor.
4. Lower the vehicle.
