Lucerne V6-3.8L (2007)
11. Position the fuel feed pipe and harness connector.
12. Connect the EVAP line quick connect fitting (1) to the sender.
13. Connect the fuel feed rear pipe quick connect fitting (3) to the sender.
14. Connect the fuel level sensor wiring harness electrical connector (4) to the sender.
15. Connect the negative battery cable.
16. Perform the following procedure in order to inspect for leaks:
1. Turn ON the ignition, with the engine OFF for 2 seconds.
2. Turn OFF the ignition for 10 seconds.
3. Turn ON the ignition, with the engine OFF.
4. Inspect for fuel leaks.
17. Install the fuel sender access hole cover.
Notice: Refer to Fastener Notice.
18. Install the fuel sender access hole cover bolts.
