Lucerne V6-3.8L VIN 2 (2006)
1. Install the antenna mast to the antenna base.
2. Install the antenna mast screws.
Tighten the screws to 1 N.m (9 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Position the digital radio antenna to the roof.
4. Route the wiring pigtail to the side in the slot on the antenna shaft and install the antenna expansion sleeve (3) and bolt (2) to the antenna shaft.
Tighten the bolt to 6 N.m (53 lb in).
5. Connect the antenna connectors (1).
6. Wrap the connectors (1) with foam tape.
7. Install the antenna cable connection above the AM/FM antenna module.
8. Install the antenna cable hold down clips.
9. Align the headliner to the roof panel.
10. Install the rear assist handles.
11. Install the upper rear quarter trim panel.
