Lucerne V6-3.8L VIN 2 (2006)
9. Place a straight edge on the engine block oil pan flange and the crankshaft rear oil seal housing flange. Use a feeler gage to ensure there is no
more than 0.10 mm (0.004 inch) step on each side. If necessary, gently rotate the crankshaft rear oil seal housing to make the step equal on each
side.
10. Notice: Refer to Fastener Notice.
Tighten the crankshaft rear oil seal housing bolts.
Tighten the bolts to 15 Nm (11 ft. lbs.) plus an additional 50 degrees using J45059.
11. Recheck the step height on each side to ensure the crankshaft rear oil seal housing did not move. If the step height is beyond specification, reinstall
the crankshaft rear oil seal housing and measure the step again. Replace the crankshaft rear oil seal housing if the clearance is still beyond
specification.
