Lucerne V6-3.8L VIN 2 (2006)
Low Tire Pressure Indicator: Description and Operation
CHECK TIRE PRESSURE SYSTEM
The Check Tire Pressure System is designed to alert the driver when there is a large change in the air pressure of one tire. The system learns the air
pressure at each tire throughout the operating speed range of the vehicle, and compares tire rotational speeds using the Anti-lock Brake System's wheel
speed sensors. The Check Tire Pressure System will not alert you before you drive the vehicle that a tire is low or flat. You must begin driving the
vehicle before the system will work properly.
The CHECK TIRE PRESSURE warning message, on the Driver Information Center (DIC), and the tire pressure warning light, on the instrument
panel cluster, will come on if the system detects a pressure difference in one of the four tires installed on the vehicle.
The Check Tire Pressure System may not warn you of a tire pressure condition if:
- More than one tire is low.
- The vehicle is moving faster than 65 mph (105 km/h).
- The system is not yet calibrated.
- The tire tread wear is uneven.
- The compact spare tire is installed.
- Tire chains are being used.
- The vehicle is being driven on a rough or frozen road.
If the anti-lock brake system warning light comes on, the check tire pressure system may not be working properly.
The system can alert you about a low tire -- but it does not replace normal tire maintenance.
When the tire pressure warning light and the "CHECK TIRE PRESSURE" message comes on, you should stop as soon as you can and check all your
tires for damage. If a tire is flat, see If a Tire Goes Flat . Also check the tire pressure in all four tires as soon as you can.
Any time you adjust a tire's pressure or have one or more tires repaired or replaced, you will need to reset (calibrate) the check tire pressure system.
You will also need to reset the system whenever you rotate the tires, buy new tires, and install or remove the compact spare tire.
Do not reset the check tire pressure system without first correcting the cause of the problem and checking and adjusting the pressure in all four tires to
the recommended amount. If you reset the system when the tire pressures are incorrect, the check tire pressure system will not work properly and may
not alert you when a tire is low or high.
To reset (calibrate) the system:
1. Turn the ignition switch to "RUN", with the engine off.
2. Press the vehicle information button on the DIC until the "PRESS TO RESET TIRE SYSTEM" message appears on the display.
3. Press and hold the DIC Set/Reset button for about five seconds. After five seconds, the display will show "TIRE PRESSURE SYSTEM RESET".
If the "TIRE PRESSURE SYSTEM RESET" message does not appear in the display after about five seconds, repeat the procedure starting with
Step 2.
The system completes the calibration process during driving. The system learns the pressure at each tire throughout the operating speed range of your
vehicle. The system normally takes between 20 and 45 minutes of driving in each of the following speed ranges to learn tire pressures: 25 to 40 mph
(40 to 64 km/h), 40 to 60 mph (64 to 96 km/h), and 60 to 85 mph (96 to 136 km/h). This time may be longer depending on your individual driving
habits. Learning need not be accumulated during a single trip. Once learned, the system will remember the tire pressures until the system is reset.
