Lucerne V6-3.8L VIN 2 (2006)
Parking Brake Warning Switch: Service and Repair
Park Brake Warning Lamp Switch Replacement
Removal Procedure
1. Remove the left sound insulator panel.
2. Disconnect the electrical connector from the park brake warning lamp switch.
3. Remove the park brake warning lamp switch retaining bolt.
4. Remove the park brake warning lamp switch.
Installation Procedure
1. Install the park brake warning lamp switch to the park brake lever assembly. Align the alignment pin to locator hole.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the park brake warning lamp switch retaining bolt.
Tighten the bolt to 2.0 Nm (18 inch lbs.).
3. Connect the electrical connector to the park brake warning lamp switch.
4. Install the left sound insulator panel.
