Lucerne V6-3.8L VIN 2 (2006)
3. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).
4. Connect the turn signal and multifunction switch assembly connector to the SIR coil connector.
Important: The abrasion sleeve must be installed back onto the steering column wire harness assembly. The ignition lock cylinder case wires and
connector must be hanging out of the middle of the abrasion sleeve.
5. Install the wire harness assembly (1) into the wire harness strap (2).
6. Install the upper and lower trim covers.
7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3.
