Lucerne V6-3.8L VIN 2 (2006)
Evaporative Canister Filter: Service and Repair
EVAPORATIVE EMISSION (EVAP) CANISTER FILTER REPLACEMENT
REMOVAL PROCEDURE
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the fuel fill pipe vent hose quick connect fitting at the evaporative emission (EVAP) canister.
3. Using a 90 degree pick or an small flat-bladed screwdriver disengage the canister filter cover clips.
4. Remove and discard the EVAP canister filter cover (3).
5. Remove and discard the EVAP canister filter cover seal (2).
6. Remove and discard the EVAP canister filter (1).
7. Clean the inside of the EVAP canister filter housing with a clean shop towel.
INSTALLATION PROCEDURE
