Lucerne V6-3.8L VIN 2 (2006)
Ignition Switch Lock Cylinder: Service and Repair
Ignition Lock Cylinder Case Replacement
Ignition Lock Cylinder Case Replacement
^
Tools Required
-
J 41396 Park Lock Cable Pliers
Removal Procedure
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the
following conditions:
^
Air bag deployment
^
Personal injury
^
Unnecessary SIR system repairs
In order to avoid the above conditions, observe the following guidelines:
^
Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring.
^
If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3.
2. Remove the ignition lock cylinder.
3. Remove the ignition switch.
4. Remove the steering column tilt head components.
5. Remove the turn signal and multifunction switch assembly only.
6. Slide the ignition lock cylinder case bracket off of the steering column shaft assembly.