Lucerne V6-3.8L VIN 2 (2006)
INSTALLATION PROCEDURE
1. Install the knock sensor.
NOTE: Refer to Fastener Notice.
IMPORTANT: DO NOT apply thread sealant to sensor threads. The sensor is coated at factory and applying additional sealant will affect the
sensors ability to detect detonation.
Tighten the sensor to 18 N.m (13 lb ft).
2. Connect the knock sensor wiring harness electrical connector to the knock sensor.
3. Fill the cooling system. Refer to Draining and Filling Cooling System (Static Fill) Draining and Filling Cooling System (Vac-N-Fill). See: Engine,
Cooling and Exhaust/Cooling System/Service and Repair
