Lucerne V6-3.8L VIN 2 (2006)
Make certain all tools connections are secure, including the following components and circuits:
^
The RS-232 communication cable port
^
The connection at the data link connector (DLC)
^
The voltage supply circuits
DO NOT disturb the tool harnesses while programming. If an interruption occurs during the programming procedure, programming failure or
control module damage may occur.
DO NOT turn OFF the ignition if the programming procedure is interrupted or unsuccessful. Ensure that all control module and DLC connections
are secure and the TIS terminal operating software is up to date.
Tech 2 Pass-Thru Method for Remote Control Door Lock Receiver (RCDLR)
Important:
The Copy and Paste procedure in Step 7 does not apply to 2006 Lucerne vehicles. Please refer to the appropriate Tire Pressure Monitor reset
procedure in SI.
1.
Verify that there is a battery charge of 12 to 16 volts. The battery must be able to maintain a charge during programming. Use an additional jump
battery if necessary.
2.
Turn on the Tech2(R).
3.
Build the vehicle using the Tech 2(R).
4.
Using the Tech 2, navigate to Vehicle Control Systems / Module ID Information / Remote Control Door Lock Receiver / Tire Information.
5.
Write down all four Pressure Sensor IDs on a sheet of paper.
6.
Using the Tech 2, navigate to Vehicle Control Systems / Module Setup / Remote Control Door Lock Receiver.
Important:
If "Replace Module Per Service Manual" message appears on the Tech 2 during this procedure, ignore the message and press the "Exit" key on
the Tech 2 and proceed to the next step. Do NOT replace the module.
7.
Run the Copy and Paste TPM Information Procedure (FO: Step 1). Follow the on-screen instructions: Turn the ignition to the ON position with the
engine OFF.
8.
Turn off the Tech 2.
9.
Turn on the Tech2.
10.
Connect the Tech 2 to the vehicle and the TIS terminal.
11.
On the TIS terminal go into SPS Programming.
12.
Select Pass Thru programming.
13.
Follow instruction on the TIS terminal. When you get to the Supported Controllers screen:
13.1. Scroll down in the top box and select RCDLR (Remote Control Door Lock Receiver).
13.2. In the lower box select Normal.
13.3. Select Next.
Important:
Some vehicles will require additional selections in the module field before you can proceed and the "Next" button is functional.
14.
When the Calibration Screen displays, select calibration 25808841 for vehicles that are NOT equipped with the remote start feature or calibration
25808842 for vehicles that are equipped with the remote start feature. After selecting a calibration, select Next.
15.
Follow the on-screen prompts until programming is completed.
