Lucerne V6-3.8L VIN 2 (2006)
Air Bag Control Module: Service and Repair
Inflatable Restraint Sensing and Diagnostic Module Replacement (With RPO Code AG1/AG2)
INFLATABLE RESTRAINT SENSING AND DIAGNOSTIC MODULE REPLACEMENT (WITH RPO CODE AG1/AG2)
REMOVAL PROCEDURE
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 8.
CAUTION: Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make
sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure
could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
2. Move both driver and passenger seat forward and/or to the rear in order to gain access to console fasteners.
3. Remove the console.
4. Remove the connector position assurance (CPA) (1) from the inflatable restraint SDM wiring harness connector (2).
5. Push down flex lock button (3) and then move sliding connector locking cover (4) to the open position.
6. Remove push-on clip (1) securing SDM wiring harness to console stud.
7. Disconnect the SDM wiring harness connector (3) from the SDM (2).
8. Remove the SDM mounting fasteners (1).
9. Remove the SDM (2) from the console floor (3).
