Lucerne V6-3.8L VIN 2 (2006)
2. Install the SDM (2) horizontally to console floor (3).
3. Point the arrow on the SDM toward the front of the vehicle.
4. Install the SDM mounting fasteners (1).
Tighten the fasteners to 9 N.m (80 lb in).
NOTE: Refer to Fastener Notice.
5. Connect the SDM wiring harness connector (3) to the SDM (2).
6. Install the push-on clip (1) securing the SDM wiring harness to the console stud.
7. Push down flex lock button (3) and then move sliding connector locking cover (4) to the close position.
8. Install the CPA (1) to the inflatable restraint SDM wiring harness connector (2).
9. Install the rear carpet into vehicle.
10. Install the front split bench seat.
11. Enable the SIR system. Refer to, SIR Disabling and Enabling Zone 8.
12. Program the new SDM into the dash integration module (DIM). Refer to Body Control Module (BCM) Programming/RPO Configuration.
IMPORTANT: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to
be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps
thoroughly to ensure that the SDM is set properly. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures
