Lucerne V6-3.8L VIN 2 (2006)
9. Remove the connector position assurance (CPA) (2, 6) from both front end sensors connector (3, 4).
10. Remove both front end sensor connectors (1, 5) from each front end sensor (3, 4).
ENABLING PROCEDURE
1. Place the ignition in the OFF position.
2. Connect both front end sensor connectors (1, 5) to each front end sensor (3, 4).
3. Install both CPAs (2, 6) into each front end sensor connector (1, 5).
4. Install both Air Bag Fuses, one in the underhood fuse center and one in the interior fuse center.
5. Replace both fuse center covers.
6. Install the rear seat.
7. Use caution while reaching in and turn the ignition switch to the ON position.The AIR BAG indicator will flash then turn OFF.
8. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System
Check - Vehicle. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and
Associated Procedures
