Lucerne V6-3.8L VIN 2 (2006)
10. Remove the lower center pillar trim.
11. Remove the connector position assurance (CPA) (6) from the seat belt retractor pretensioner - RF connector (5).
12. Disconnect the seat belt retractor pretensioner - RF connector (5) from the seat belt retractor pretensioner - RF (4).
13. Remove the CPA (1) from the SIS - right connector (2).
14. Remove the SIS - right connector (2) from the SIS (3).
15. Remove the trim molding from the rear quarter pillar.
16. Remove the CPA from the roof rail module - right connector.
17. Disconnect the roof rail module - right connector from the vehicle harness connector.
ENABLING PROCEDURE
1. Place the ignition in the OFF position.
2. To enable the seat belt retractor pretensioner - RF and SIS - right go to step 3. To enable the roof rail module - right go to step 8.