Lucerne V6-3.8L VIN 2 (2006)
10. Remove the lower center pillar trim.
11. Remove the connector position assurance (CPA) (6) from the seat belt retractor pretensioner - LF connector (5).
12. Disconnect the seat belt retractor pretensioner - LF connector (5) from the seat belt retractor pretensioner - LF (4).
13. Remove the CPA (1) from the SIS - left connector (2).
14. Remove the SIS - left connector (2) from the SIS (3).
15. Remove the trim molding from the rear quarter pillar.
16. Remove the CPA from the roof rail module - left connector.
17. Disconnect the roof rail module - left connector from the vehicle harness connector.
ENABLING PROCEDURE
1. Place the ignition in the OFF position.
2. To enable the seat belt retractor pretensioner - LF and SIS - left go to step 3. To enable the roof rail module - left go to step 8.
