Lucerne V6-3.8L VIN 2 (2006)
8. Using the J 24319-B separate the outer tie rods from the steering knuckles.
9. Remove the power steering pressure and return hoses (1, 2) from the power steering gear.
10. If equipped, disconnect the variable effort steering electrical connector.
11. Remove the left stabilizer shaft insulator.
12. Disconnect the tie rod ends from the knuckles.
13. Remove the power steering gear mounting bolts.
14. Remove the power steering gear through the left wheel opening.
15. Transfer the outer tie rods if replacing the power steering gear.
Installation Procedure
1. Install the power steering gear through the left wheel opening.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the power steering gear mounting bolts.
^
Tighten the power steering gear mounting bolts to 95 Nm (70 ft. lbs.).
3. Install the left stabilizer shaft insulator.