buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

All Technical Service Bulletins for Steering Shaft: > < Steering Wheel Control Switch - Left|Page 17229
Page 1
background image

Steering Shaft: Customer Interest
Steering - Bump/Clunk on Slow Speed Turns

ENGINEERING INFORMATION

Bulletin No.: 06-02-35-009G

Date: June 15, 2009

Subject: EI06035 - Power Steering Clunk/Bump While Making Turns at Slow Speeds, Column, Intermediate Shaft, Intermittent (Replace Intermediate
Shaft)

Models:

2006-2009 Buick Lucerne
Equipped with V6 Engine (RPOs L26, L36, LZ9)
Refer to GMVIS

Supercede:
This bulletin is being revised to update the correction information. Please discard Corporate Bulletin Number 06-02-35-009F (Section 02 - Steering).

Condition

Some customers may comment on a power steering clunk type noise or a rubbing feel/noise when making left or right turns at slow speeds. This
condition is most noticeable during parking lot maneuvers. 

Correction

DO NOT replace the steering gear for this concern.

If the customer's concern can be duplicated, replace the intermediate shaft with a new designed shaft, GM P/N 25810450. Refer to Intermediate Steering
Shaft Replacement in SI. This new design intermediate shaft eliminates the clunk or looseness in the steering when performing parking lot maneuvers or
low speed turns.

Parts Information

Warranty Information

For vehicles repaired under warranty, use the table above.

Disclaimer

All Technical Service Bulletins for Steering Shaft: > < Steering Wheel Control Switch - Left|Page 17229