Lucerne V6-3.8L VIN 2 (2006)
Installation Procedure
1. Connect the air tube to the air dryer.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the air tube with the harness tie and the bolt on the air compressor bracket.
3. Install the air tube on the vehicle with three clips.
4. Connect the air tube to the left and right rear shock absorbers.
5. Install two metal clips on the air tube and the vehicle. Place each clip immediately forward of the wheel house fold-over tabs on the LH and RH
side of the vehicle.
6. Install both rear wheels.
Important: Before driving the vehicle, turn the ignition on and wait approximately 45 seconds. This will ensure that the air adjustable shock
absorbers are filled with residual pressure.
7. Lower the vehicle. Refer to Lifting and Jacking the Vehicle.
