Lucerne V6-3.8L VIN 2 (2006)
7. Remove the accumulator assembly.
8. Remove the 2-1 manual servo piston assembly and the filter.
9. Remove the seal.
10. Disassemble and inspect the accumulator and the 2-1 manual servo assemblies for foreign debris and clean as necessary.
Installation Procedure
Important: The seal must be installed as shown. If it is not installed, or is installed in the wrong location, the transmission will operate only in
reverse.
1. Install the 2-1 manual servo piston assembly seal. Lubricate the seal with automatic transmission fluid.
2. Install the 2-1 manual servo piston assembly and the filter. Make sure that the servo pin engages the band assembly.
3. Install the accumulator assembly.
