Lucerne V6-3.8L VIN 2 (2006)
Transmission Temperature Sensor/Switch: Service and Repair
Fluid Temperature Sensor Replacement
Fluid Temperature Sensor Replacement
Removal Procedure
1. Remove the case side cover.
2. Remove the end of the wiring harness assembly (2) with fluid temperature sensor (1) from the retaining clip.
3. Disconnect the wiring harness connector from the fluid temperature sensor (1).
4. Remove the fluid temperature sensor (1).
Installation Procedure
1. Connect the wiring harness connector to the fluid temperature sensor (1).
2. Install the wiring harness (2) and fluid temperature sensor (1) into the retaining clip.
3. Install the case side cover.
4. Fill the transaxle to the proper level. Refer to Fluid Capacity Specifications.
5. Inspect the transaxle fluid level.
6. Inspect for fluid leaks.
Important: It is recommended that transmission adaptive pressure (TAP) information be reset.
7. Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP
values. Transmission performance may be affected as new TAP values are learned.
Reset the TAP values. Refer to Transmission Adaptive Functions.
