Lucerne V6-3.9L (2009)
Electronic Brake Control Module: Recalls
Campaign - EBCM Harness Contact
SERVICE UPDATE
Bulletin No.: 10142
Date: May 12, 2010
Subject: 10142 - Service Update for Inventory and Customer Vehicles - EBCM Harness Contact - Expires with Base Warranty
Models:
2009-2010 Buick Lucerne
2009-2010 Cadillac DTS
Equipped with a V8 Engine
This service update includes vehicles in dealer inventory and customer vehicles that return to the dealership for any reason. It will expire at the end of the
involved vehicle's New Vehicle Limited Warranty period.
Purpose
This bulletin provides a service procedure to secure the electronic brake control module (EBCM) wire harness to eliminate contact on certain
2009-2010 model year Buick Lucerne and Cadillac DTS vehicles equipped with a V 8 engine. The EBCM wire harness on these vehicles may not be
properly secured, causing wear of the protective conduit. If the conduit wears away and a wire contacts a stud, transaxle cooler line, or left front of the
transaxle, a short circuit could occur and the telltale lamps could illuminate and/or cause the vehicle to go into a reduced power mode.
This service procedure should be completed as soon as possible on involved vehicles currently in dealer inventory and customer vehicles that
return to the dealer for any type of service during the New Vehicle Limited Warranty coverage period.
Vehicles Involved
A list of involved vehicles currently in dealer inventory is available on the "Service Update Bulletin Information" link under the "Service" tab in GM
GlobalConnect (GM) or attached to the GlobalConnect message (Canada) used to release this bulletin. Customer vehicles that return for service, for any
reason, and are still covered under the vehicle's base warranty, and are within the VIN breakpoints provided below, should be checked for vehicle
eligibility in the appropriate system listed below.
Important
Dealers are to confirm vehicle eligibility prior to beginning repairs by using GMVIS (dealers using WINS) or the Investigate Vehicle History
link (dealers using GWM). Not all vehicles within the above breakpoints may be involved.
Parts Information
Some vehicles may require a tie strap.
Service Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in SI.
2. Locate the electronic brake control module EBCM harness. This harness is located on the driver's side of the vehicle near the frame, power
steering lines, and transaxle.
