Lucerne V6-3.9L (2009)
8. Remove the following items:
*
The spacer ring (1) using J 8059
*
The spider assembly (2)
*
The spacer ring (3) using J 8059
*
The inboard boot (4)
9. Discard both rings and the inboard boot.
10. Clean the halfshaft bar (5). Use a wire brush to remove any rust in the boot mounting area.
11. Clean the following items with cleaning solvent:
*
The tripot balls
*
The needle rollers
*
The housing
12. Remove all traces of old grease and any contaminates. Dry all parts.
13. Inspect the following parts for damage or wear:
*
The tripot joint spider assembly
*
The housing
*
The needle rollers
Assembly Procedure
