Lucerne V8-4.6L (2008)
11. Remove the hose bracket bolt from the strut assembly and remove the hose.
Installation Procedure
1. Remove the rubber plug from the brake hose bolt hole of the brake caliper.
Important: Install NEW copper brake hose gaskets.
2. Assemble the brake hose bolt and the NEW copper brake hose gaskets to the brake hose.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
3. Install the brake hose bolt to the brake caliper.
Tighten the brake hose bolt to 40 N.m (30 lb ft).
Notice: Make sure the brake hose is not twisted or kinked after installation. Damage to the hose could result.
4. Install the brake hose to the brake hose bracket.
5. Install the brake hose retainer to the brake hose.
