Lucerne V8-4.6L (2008)
1. Route the drive belt around all the pulleys except for the power steering pump.
2. Lower the vehicle.
3. Install a 1/2 inch drive breaker bar to the drive belt tensioner.
4. Push down on the breaker bar in order to release the tension and route the belt around the power steering pump pulley.
Ensure the belt is seated on all pulleys.
5. Slowly return the tensioner to its original position.
6. After drive belt installation, inspect the drive belt for the proper routing and correct alignment.
7. Install the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (See: Body and Frame/Fender/Front Fender/Front Fender
Liner/Service and Repair).
8. Start the engine and check for proper belt and accessory operation.
