Lucerne V8-4.6L (2008)
Notice: Avoid damaging the lock ring. Use only J-45722 to prevent damage to the lock ring.
Notice: Do Not handle the fuel sender assembly by the fuel pipes. The amount of leverage generated by handling the fuel pipes could damage the
joints.
Important:
*
The fuel module assembly may spring up from its position.
*
When removing the fuel module assembly from the fuel tank, be aware that the reservoir bucket is full of fuel. It must be tipped
slightly during removal to avoid damage to the float. Discard the fuel module assembly O-ring seal and replace it with a new one.
*
Carefully discard the fuel in the reservoir bucket into an approved container.
Important: Do NOT use impact tools. Significant force will be required to release the lock ring. The use of a hammer and screwdriver is
not recommended. Secure the fuel tank in order to prevent fuel tank rotation.
9. Use the J 45722 and a long breaker-bar in order to unlock the fuel module lock ring. Rotate the lock ring in a counterclockwise direction.
Important: When removing the module from the fuel tank, be aware that the module reservoir bucket is full of fuel. The module must be
tipped slightly during removal to avoid bending the fuel level sensor float arm.
10. Remove the lock ring (1) and the fuel sender assembly (2).
11. Slowly raise the module until the fuel level sensor float arm is just visible.
