Lucerne V8-4.6L (2008)
1. Install the MAP sensor.
2. Install the MAP sensor bracket.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
3. Install the MAP sensor bracket bolt.
Tighten the bolt to 10 N.m (89 lb in).
4. Connect the engine harness electrical connector (4) to the MAP sensor.
5. Install the fuel injector sight shield, if necessary. Refer to Fuel Injector Sight Shield Replacement (See: Fuel Delivery and Air Induction/Fuel
Injector/Service and Repair/Fuel Injector Sight Shield Replacement).
