Lucerne V8-4.6L (2008)
1. Install the power steering flow control spring (2) to the power steering pump.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
2. Install the power steering flow control valve assembly (3) to the power steering pump.
Tighten the power steering flow control valve assembly (5) to 75 N.m (55 lb ft).
3. Position the power steering pressure hose (3) to the power steering pump, with the 2 NEW washers (2) and install the banjo bolt (1).
Tighten the power steering pressure hose banjo bolt to 55 N.m (41 lb ft).
4. Lower the vehicle.
5. Bleed the power steering system. Refer to Power Steering System Bleeding (See: Power Steering Bleeding/Service and Repair).
