Lucerne V8-4.6L (2008)
7. Remove the outer tie rods retaining nuts.
8. Using the J 24319-B separate the outer tie rods from the steering knuckles.
9. Remove the power steering pressure and return hoses (1, 2) from the power steering gear.
10. If equipped, disconnect the variable effort steering electrical connector.
11. Remove the left stabilizer shaft insulator. Refer to Stabilizer Shaft Insulator Replacement (See: Suspension/Stabilizer Bar/Stabilizer
Bushing/Service and Repair/Front Suspension).
12. Disconnect the tie rod ends from the knuckles.
13. Remove the power steering gear mounting bolts.
14. Remove the power steering gear through the left wheel opening.
15. Transfer the outer tie rods if replacing the power steering gear.
Installation Procedure
1. Install the power steering gear through the left wheel opening.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
2. Install the power steering gear mounting bolts.
Tighten the power steering gear mounting bolts to 95 N.m (70 lb ft).
3. Install the left stabilizer shaft insulator. Refer to Stabilizer Shaft Insulator Replacement (See: Suspension/Stabilizer Bar/Stabilizer
Bushing/Service and Repair/Front Suspension).
