Lucerne V8-4.6L (2008)
4. Install the power steering pressure and return hoses (1, 2) to the power steering gear.
Tighten the power steering pressure and return hoses to 30 N.m (22 lb ft).
5. If equipped, connect the variable effort steering electrical connector.
6. Install the outer tie rod (1) to the steering knuckles.
7. Install the outer tie rod retaining nuts.
Tighten the outer tie rod retaining nuts to 30 N.m (22 lb ft) plus an additional 180 degrees.
8. Connect the intermediate shaft to the power steering gear.
9. Install the intermediate shaft lower pinch bolt.
Tighten the intermediate shaft lower pinch bolt to 47 N.m (37 lb ft).
10. Install the power steering gear heatshield. Refer to Steering Gear Heat Shield Replacement (See: ).
11. Install the tires and wheels. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair).
12. Lower the vehicle.
