Lucerne V8-4.6L (2008)
Pressure Regulating Solenoid: Service and Repair
Pressure Control Solenoid Valve Replacement
Removal Procedure
1. Remove the case side cover. Refer to Control Valve Body Cover Replacement (See: Automatic Transmission/Transaxle/Valve Body/Service and
Repair/4T65-E - Automatic Transaxle/Control Valve Body Cover Replacement).
2. Disconnect the transaxle wiring harness.
3. Using a small screwdriver or pick, remove the pressure control solenoid valve retainer (314E) from the control valve body (301).
4. Remove the pressure control solenoid (322).
5. Remove the O-ring seals (307, 316) from the PC solenoid valve (322) ONLY if they are damaged.
Installation Procedure
1. Install new O-ring seals (307, 316) onto the pressure control (PC) solenoid valve (322), if they had been removed.
2. Install the pressure control solenoid (322).
3. Hold the PC solenoid valve (322) in the control valve body (301). Install the pressure control solenoid valve retainer (314E) into the control valve
body (301).
4. Connect the transaxle wiring harness.
5. Install the case side cover. Refer to Control Valve Body Cover Replacement (See: Automatic Transmission/Transaxle/Valve Body/Service and
Repair/4T65-E - Automatic Transaxle/Control Valve Body Cover Replacement).
Important: It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to
relearn TAP values. Transmission performance may be affected as new TAP values are learned.
6. Reset the TAP values. Refer to Transmission Adaptive Functions (See: Automatic Transmission/Transaxle/Description and Operation/4T65-E -
Automatic Transaxle/Transmission Adaptive Functions).
