Lucerne V8-4.6L (2008)
Parking Pawl: Service and Repair
Parking Pawl Replacement
Removal Procedure
1. Remove the lower valve assembly. Refer to Control Valve Body Assembly Replacement (See: Valve Body/Service and Repair/4T80-E -
Automatic Transaxle).
2. Remove the parking gear. Refer to Parking Gear Replacement (See: Park Gear/Service and Repair).
3. Move the manual shaft from the park position.
4. Drive out the parking pawl pivot pin using a pin punch. Push down on the spring while driving the pin out.
5. Remove the parking pawl and the spring.
6. Inspect the following:
*
Parking pawl tooth for damage
*
Parking pawl spring for over expansion
*
Pivot pin for scorning, excessive wear
Installation Procedure
1. Place the pawl in the case slot. Attach the spring to the pawl.
2. Insert the pivot pin through the spring and pawl. The hook end of the spring locates on the case and the square end on top of the parking pawl.
3. Install the pivot pin using a mallet.
4. Install the park gear. Refer to Parking Gear Replacement (See: Park Gear/Service and Repair).
5. Install the lower valve assembly and the bottom pan. Refer to Control Valve Body Assembly Replacement (See: Valve Body/Service and
