Lucerne V8-4.6L (2008)
Seals and Gaskets: Service and Repair
Case Cover Axle Seal Replacement - Left
Case Cover Axle Seal Replacement - Left Side
Tools Required
J 39051-2 Left Seal Driver
Removal Procedure
1. Remove the left drive axle. Refer to Wheel Drive Shaft Replacement (See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and
Repair).
Important : Be careful not to damage the transmission case cover when removing the seal.
2. Remove the drive axle seal (1). Pry out the seal from the transmission.
3. Inspect the drive axle seal mating surface on the drive axle housing for corrosion, grooves or nicks.
4. Clean the drive axle seal mating surface on the drive axle housing with crocus cloth.
Installation Procedure
Important: Be careful not to damage the transmission case cover when installing the drive axle seal.
1. Install the left-hand drive axle seal (1) using the J 39051-2 and a hammer.
2. Install the left drive axle. Refer to Wheel Drive Shaft Replacement (See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and
Repair).
