Lucerne V8-4.6L (2008)
Torque Converter Cover: Service and Repair
4T80-E - Automatic Transaxle
Torque Converter Cover Replacement
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Remove the attaching bolts and the engine-to-transmission brace.
3. Remove the torque converter cover.
Installation Procedure
Notice: Refer to Fastener Notice.
1. Install the torque converter cover.
Tighten the cover bolt to 12 N.m (106 lb in).
2. Install the engine-to-transmission brace and attaching bolts.
Tighten the bolts to 47 N.m (35 lb ft).
3. Lower the vehicle.
