Lucerne V8-4.6L (2008)
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
4. Align the following items:
*
The seal (1)
*
The swage ring (2)
*
The halfshaft bar
Tighten each bolt of J 41048 180 degrees at a time using a ratchet wrench. Alternate between each bolt until both sides are bottomed.
5. Put a light coat of grease from the service kit on the ball grooves of the inner race and the outer race (1).
6. Hold inner race 90 degrees to the centerline of the cage (4) with the lands of the inner race aligned with the windows of the cage and insert the
inner race into the cage.
7. Hold the cage and the inner race 90 degrees to the centerline of the outer race (1) and align the cage windows (3) with the lands of the outer race
(2).
Important: Ensure that the retaining ring side of the inner race faces the halfshaft bar.
8. Place the cage (4) and the inner race into the outer race (1).
