Park Avenue V6-3.8L SC VIN 1 (2005)
INSTALLATION PROCEDURE
1. Paint the new rear object sensor. Refer to Basecoat/Clearcoat Paint Systems in Paint/Coatings.
IMPORTANT: Do not refinish previously painted sensors. Excess paint build up will cause the sensor to be inoperative
2. Check to ensure the paint thickness does not exceed 6 mils. Use a paint thickness gauge suitable for non-ferrous metals. Refer to Paint Gages in
Paint/Coatings.
3. Install the rear object sensor bezel by pressing ring in until it is flush with fascia.
4. Align the keyhole (2) with the key (1). Press the sensor bezel into the fascia.
5. Install the housing to the bezel from the back of the rear fascia. Press into the cut outs until fully secured.
6. Install the spring (1) to the housing (2).
IMPORTANT: The spring keys must be on the top and bottom of the housing.
