Park Avenue V6-3.8L SC VIN 1 (2005)
1. Connect the electrical connectors.
2. Install the clips (1) on the electrical harness to the front door control module (2).
3. Engage the lower hooks on the door trim panel into the slots in the door.
4. Align the remaining hooks to the slots in the door.
5. Push the door trim panel downwards in order to fully seat the hooks into the door.
6. Ensure that the door trim panel is fully seated prior to fastener installation.
7. Install the push-in retainer (1) in the defroster duct.
Notice: Refer to Fastener Notice in Cautions and Notices.
8. Install the fastener (4) in the courtesy lamp opening.
Tighten the fastener to 0.6 N.m (5 lb in).
9. Install the courtesy lamp assembly (5).
10. Install the fasteners (3) in the armrest.
Tighten the 2 fasteners to 0.6 N.m (5 lb in).
11. Install the armrest cover plate (2).
1. Insert the rear retainer tabs into the slot in the armrest pull cup.
2. Snap the front edge down into the hole.