Park Avenue V6-3.8L SC VIN 1 (2005)
Body Emblem: Service and Repair
Emblem/Nameplate Replacement - Quarter Panel
Emblem/Nameplate Replacement - Quarter Panel
Tools Required
J 25070 Heat Gun
Removal Procedure
1. Apply tape for alignment marks to aid in the installation of the emblem/nameplate.
2. Use the tape to protect the mounting surface during removal.
3. Heat the emblem/nameplate using the J 25070 . Apply heat using a circular motion for about 30 seconds.
Notice: Refer to Exterior Trim Emblem Removal Notice in Cautions and Notices.
4. Use a plastic, flat-bladed tool to remove the emblem/nameplate from the panel surface.
5. When replacing a emblem/nameplate, remove all adhesive as follows:
*
For body panels use a 3M(TM) Scotch Brite molding adhesive remover disk 3M(TM) P/N 07502 or equivalent.
*
For plastic panels use a lint-free cloth and Varnish Makers and Painters (VMP) naphtha or a (50/50 mixture) by volume of isopropyl alcohol
and water to remove the adhesive.
Installation Procedure
Important: Apply the emblem/nameplate in an environment that is free from dust or other dirt that could come into contact with the
sticky backing. Foreign material may cause improper adhesion.
1. Ensure the area where the emblem/nameplate will be installed is clean and dry.
