Park Avenue V6-3.8L SC VIN 1 (2005)
Keyless Entry Transmitter Battery: Service and Repair
TRANSMITTER BATTERY REPLACEMENT
REMOVAL PROCEDURE
1. Insert a small coin between the 2 halves of the transmitter case at the slot provided near the key ring hole.
2. Twist the coin in order to open the case.
3. Open the transmitter case.
4. Slide the battery out of the bracket to remove (2).
NOTE: Refer to Handling ESD Sensitive Parts Notice in Service Precautions.
INSTALLATION PROCEDURE
1. Install the battery (2) with the positive (+) side up.Use one 3 V CR2032 battery (or the equivalent).
2. Close the transmitter case (6, 4).
3. Ensure that the seal is in position. Align the 2 halves of the case and snap the 2 halves together.
4. Resynchronize the transmitter.
5. Replace the batteries when the range of the transmitter decreases to less than 7 m (23 ft).