Park Avenue V6-3.8L SC VIN 1 (2005)
12. Remove the park brake cable bracket (2) from the brake caliper (1).
Leave the park brake cable attached to the cable bracket (2).
13. Disconnect the park brake cable from the park brake lever on the brake caliper.
14. Remove the lower brake caliper pin bolt.
15. Rotate the brake caliper up.
16. Remove the brake caliper from the upper brake caliper pin bolt.
Installation Procedure
1. If reusing the brake caliper retainers, clean the sleeves using denatured alcohol, or equivalent.
2. Lubricate the brake caliper pin bolts with a thin coat of high temperature silicone lube.
3. Install the brake caliper to the upper caliper pin bolt.
4. Rotate the brake caliper down over the brake pads into the brake caliper bracket.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the brake caliper pin bolts.
Tighten the brake caliper pin bolts to 27 Nm (20 ft. lbs.).
6. Remove the plugs in the brake hose end.
Important: Install NEW copper brake hose gaskets.
7. Assemble the brake hose bolt and the NEW copper brake hose gaskets to the brake hose.
8. Install the brake hose to caliper bolt to the brake caliper.
Tighten the brake hose to caliper bolt to 45 Nm (33 ft. lbs.).
9. Connect the park brake cable to the park brake lever on the brake caliper.
