Park Avenue V6-3.8L SC VIN 1 (2005)
5. Assemble the brake hose bolt and the NEW copper brake hose gaskets to the brake hose.
6. Install the brake hose to caliper bolt to the brake caliper.
Tighten the brake hose to caliper bolt to 45 Nm (33 ft. lbs.).
7. Bleed the brake system.
8. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
9. Slowly release the brake pedal.
10. Wait 15 seconds, then repeat steps 8-9 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
11. Remove the two wheel lug nuts retaining the brake rotor to the hub.
12. Install the tire and wheel assembly.
13. Lower the vehicle.
