Park Avenue V6-3.8L SC VIN 1 (2005)
10. Install the park brake cable bracket (2) to the brake caliper (1).
Tighten the park brake cable bracket bolt to 43 Nm (32 ft. lbs.).
11. Install the front park brake cable (3) to the park brake cable connector (1).
12. Bleed the brake system.
13. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
14. Slowly release the brake pedal.
15. Wait 15 seconds, then repeat steps 12-13 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
16. Install the tire and wheel assembly.
17. Lower the vehicle.
